I am helping a friend to disassemble, clean and lube his newly acquired MarK I, and I cannot figure out how to remove the trigger pivot pin. It does not have a spring bearing on the pin as do the Mark II and III, and the pin seems to be solidly locked in place, but I can't see what is holding it.
I'd appreciate any guidance!
Ruger Mark I Disassembly
Moderators: Bullseye, Moderators
- blue68f100
- Master contributor
- Posts: 1997
- Joined: Mon May 25, 2009 10:31 pm
- Location: Piney Woods of East Texas
For reference use Bullseye's guide at www.guntalk-online.com/service.html
David
SS MKIII 6 7/8" Fluted Hunter. Mueller Quick Shot, Bushnell 2x Scope, Hogue Rubber Grips
Custom Built 1911
SS MKIII 6 7/8" Fluted Hunter. Mueller Quick Shot, Bushnell 2x Scope, Hogue Rubber Grips
Custom Built 1911
The Mark I series pistols have a little "E" clip on the left side of the trigger holding (locking) the trigger pivot pin in place. You have to take care to replace the clip with some care or it will slip off of the pin and go down underneath the trigger. Later I'm going to add a section just for the Mark I style pistol. Too many folks have been asking questions regarding that model that make investing the time to create the instruction page worthwhile.
R,
Bullseye
R,
Bullseye