MARKII jamming
Posted: Tue Apr 25, 2017 11:37 am
Have a problem I am hoping one of you guys and help me solve.
The gun is a Mark II frame with a ten inch fluted Tac Sol upper. Ruger stainless mark II bolt. With the factory upper it ran flawless. Since the TAC SOL upper was added it will get a fail to extract every so often. Maybe one round in five mags or so.
I figured a new extractor would help so I tried both the VQ Exact Edge Extractor and the Ron Power unit. Both have the same problem. When you close the bolt on a full magazine the round gets jammed, on an angle. It doesn’t even get in to the chamber.
I don’t know how an extractor could cause this but it didn’t do this with the factory extractor. I am about to call Ruger and have them send me one but I figured I’d ask here first.
Thoughts?
Thanks
Vic
The gun is a Mark II frame with a ten inch fluted Tac Sol upper. Ruger stainless mark II bolt. With the factory upper it ran flawless. Since the TAC SOL upper was added it will get a fail to extract every so often. Maybe one round in five mags or so.
I figured a new extractor would help so I tried both the VQ Exact Edge Extractor and the Ron Power unit. Both have the same problem. When you close the bolt on a full magazine the round gets jammed, on an angle. It doesn’t even get in to the chamber.
I don’t know how an extractor could cause this but it didn’t do this with the factory extractor. I am about to call Ruger and have them send me one but I figured I’d ask here first.
Thoughts?
Thanks
Vic