The place to discuss firearms related modifications or home made shooting equipment.
Moderators: Bullseye, Moderators
-
Decado
- New member
- Posts: 26
- Joined: Sat Jul 28, 2007 4:38 pm
Post
by Decado » Thu May 15, 2008 12:14 pm
How do I mod them to fit the MKIII? I know it should not be hard, I am just wondering what tools you guys use to cut away material for the mag release.
-
jrayb95
- New member
- Posts: 32
- Joined: Sat Jul 14, 2007 4:37 pm
- Location: Montrose, CO
Post
by jrayb95 » Thu May 15, 2008 6:18 pm
I used an Exacto Knife. It doesn't take much.
-
Bullseye
- Site Admin/Host
- Posts: 6382
- Joined: Sun Aug 14, 2005 12:23 pm
- Location: USA
Post
by Bullseye » Thu May 15, 2008 9:51 pm
You can use a 3/8ths inch drill bit to start and get the outline and then clean it out with an x-acto knife.
R,
Bullseye
-
Decado
- New member
- Posts: 26
- Joined: Sat Jul 28, 2007 4:38 pm
Post
by Decado » Fri May 16, 2008 5:21 am
Thanks J and Bullseye for responding
, I figured I could use an exacto knife for that, just wanted to get an idea before I go off cutting on some grips.
Thank you for the quick response.