December 2012

The place to post targets and info for the GTOL .22 Postal League.

Moderators: Bullseye, perazzi, Moderators

Post Reply
DeerSpy
Regular contributor
Regular contributor
Posts: 67
Joined: Fri Nov 02, 2007 9:09 pm

December 2012

Post by DeerSpy » Mon Dec 03, 2012 5:12 pm

S&W M41 with red dot 25 yard NMC

SF 82-X
TF 94-2X
RF 96-3X
total 272-6X

DeerSpy
Regular contributor
Regular contributor
Posts: 67
Joined: Fri Nov 02, 2007 9:09 pm

Post by DeerSpy » Tue Dec 11, 2012 10:31 am

S&W M41 with red dot 25 yards NMC

SF 83-1X
TF 98-4X
RF 92-2X

total 273-7X

DeerSpy
Regular contributor
Regular contributor
Posts: 67
Joined: Fri Nov 02, 2007 9:09 pm

Post by DeerSpy » Tue Dec 18, 2012 12:18 pm

S&W m41 red dot 25yards out side

SF 84-0X
TF 93-2X
RF 96-3X

total 273-5X

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6371
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Wed Dec 19, 2012 6:42 am

Were these scores attained with the M-41 you were having bolt issues with? Did you ever contact Smith about your slide and bolt?

R,
Bullseye
Image

DeerSpy
Regular contributor
Regular contributor
Posts: 67
Joined: Fri Nov 02, 2007 9:09 pm

Post by DeerSpy » Wed Dec 19, 2012 10:06 pm

yes this is the same M41, I put it back to gather with new bolt and new pin from Gil Hebard and it was not much better than with old bolt, I called S&W but the guy I talked to did not know as much as i did and he said he did not know if it should be tight or not, and he would just put it back gather and shoot it. i have a friend with a mill and I think i will have him cut a step in top of bolt so i can lay a L shaped shim in ther to take up slack so it does not hammer pin, I think it has lose from the time it was new. I will need to buy a new slide when i get rich!

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6371
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Thu Dec 20, 2012 11:44 pm

If you still have both bolts, mill the old one for a shim and keep the new one at factory specs until you have a chance to pick up another slide. After you shoot it for a while you may decide the modified bolt is all you need and keep the other as a spare.

R,
Bullseye
Image

Post Reply