Baby powder

snowman1 · Post by **snowman1** » Wed Mar 23, 2011 9:05 pm

Does any one use baby powder when reloading, I use the plain kind on my hands to prevent finger prints and hand oils on brass and bullets, look like they just came out of the box.

blue68f100 · Post by **blue68f100** » Wed Mar 23, 2011 10:35 pm

I have never worried about prints. Normally they get shot up pretty quickly.

I classify Powder as an fine abrasive. I think it would make good finger prints more than prevent them when it comes to oily surfaces. I use latex/nitrile gloves when handling new polished brass. I also use NuFinish in my tumbler so it will leave a light coating of wax on the brass. This helps prevent tarnishing.

Post by **Bullseye** » Thu Mar 24, 2011 6:48 am

I wear latex gloves now when reloading. Makes cleaning up a lot easier.

R,
Bullseye

bearandoldman · Post by **bearandoldman** » Thu Mar 24, 2011 8:38 am

Bullseye wrote:I wear latex gloves now when reloading. Makes cleaning up a lot easier.

R,
Bullseye

Added asset is you do not leave any prints on upur reloads?????

Yleefox · Post by **Yleefox** » Tue Mar 29, 2011 5:54 pm

Latex gloves, hummmm, never thought of using them for reloading. I've tried using them when I clean my guns in an effort to keep my hands clean and finger oils off my guns, but they haven't held up too well.

I'm going to give them a try on the reloading bench. Thanks for the tip.

Y

FlyerTom · Post by **FlyerTom** » Fri Apr 15, 2011 3:43 am

Latex doesn't stand up too well against solvents and oil. You may want to try the blue nitrile-type gloves instead. Available at Harbor Freight for cheap, I find them pretty durable.

Post by **Bullseye** » Fri Apr 15, 2011 5:41 am

Thanks, I call them latex but they're really blue nitrile gloves. They are pretty durable but on occasion I've had to double them up for coverage around sharp edges.

R,
Bullseye

greener · Post by **greener** » Fri Apr 15, 2011 9:18 pm

Bullseye wrote:Thanks, I call them latex but they're really blue nitrile gloves. They are pretty durable but on occasion I've had to double them up for coverage around sharp edges.

R,
Bullseye

Also keeps the lead off our hands

Post by **Bullseye** » Sat Apr 16, 2011 6:54 am

They also work well when I'm working on the Mill. Keeps the cutting fluids and oils off my hands.

R,
Bullseye