New LCP requires me to pull trigger back at least 1/2 way then release trigger and then pull to fire.
When I take the slide off and cock the hammer with my thumb it fires correctly but when I put slide back on, the trigger will not reset with out pulling it and releasing it.
Any ideas?
LC9 Trigger not resetting
Moderators: Bullseye, Moderators
Sounds like issues with the disconnector. The slide has to be fully closed for the disconnector to allow the trigger to fire the pistol and prevent an out-of-battery detonation. With the slide off, the disconnector operates as if the slide is closed and the disconnector lever is in the slide pocket for being in the fully closed position and allowing the trigger to operate the hammer. This is where I'd look.
R,
Bullseye
R,
Bullseye
![Image](https://guntalk-online.com/images/target.gif)
Thanks Bullseye
Cleaned out plunger in slide with Gun Scrubber, the second time, it was gummed up.
I had installed a Belt Clip (See Below Link) if you tighten the allen set screw too tight it causes a reset problem.
http://www.amazon.com/gp/product/B008AD ... UTF8&psc=1
Cleaned out plunger in slide with Gun Scrubber, the second time, it was gummed up.
I had installed a Belt Clip (See Below Link) if you tighten the allen set screw too tight it causes a reset problem.
http://www.amazon.com/gp/product/B008AD ... UTF8&psc=1