Installing HiVis sights on a Ruger Mark II

tguil · Post by **tguil** » Fri Jul 20, 2007 10:59 am

I just got a HiVis sight kit from Ruger which I plan to install ASAP on my Mark II. The installation directions look look pretty straight forward. Any further suggestions? I do have gunsmithing screw drivers.

I'm most concerned about loosening the front sight. It may be a bit tight.

Tom

Post by **Bullseye** » Fri Jul 20, 2007 11:53 am

It is pretty straight forward. Be sure to place the barrel in a padded vise and use positive pressure with the screwdriver. You can wrap the end of the barrel with some tape to protect the finish in case the screwdriver slips. If the screw doesn't release, rock it back and forth to break it free.

R,
Bullseye