Page 1 of 1
Model 41 Sights
Posted: Mon Feb 15, 2010 10:52 am
by Anchor
Recently purchased a Model 41, Have read almost everything on the forums concerning 41's. Lots of great info. I have ordered a buffer and have quite a bit of CCI SV on hand. Haven't been to range yet but as soon as buffer is in will quit admiring the 41 and do some shooting. Plan to stick with iron sights for awhile. Would like to do someting to front blade to give some contrast with rear sight. Any ideas? Thanks.
Front sight
Posted: Mon Feb 15, 2010 1:03 pm
by stewswanson
On my mark 3 I have a piece of self adhesive label material (white) on the front sight. I then used a Flourescent Marker (hot pink) and colored it in.
It has a nice contrast with the rear sight, black target and white range wall.
If you find it does not work for you, peel it off.
Stew
Posted: Mon Feb 15, 2010 7:58 pm
by Bullseye
Some inexpensive ladies fingernail polish works well too. There's plenty of vibrant colors to choose. The finish is durable and will resist most solvents. To remove use some polish remover or acetone.
R,
Bullseye
Posted: Tue Feb 16, 2010 11:09 am
by Anchor
Thanks Bullseye and Stew. Will try one or both.
Anchor
Posted: Sun Apr 25, 2010 1:04 pm
by johnnywitt
Testors Modeling Paint in Neon Blaze Orange with a final coat of ladies clear coat nail polish to completely seal it. Neon Green works good as well.