Page 1 of 1
V-Comp help
Posted: Fri Feb 19, 2010 11:27 am
by cheryld
I just installed a V-Comp to my Ruger MKIII Hunter. After I shoot later this afternoon I will remove it to clean the buildup. What is the best way to do it? Also, does the O-ring need to be removed? If so, how does it come off? Thanks Cheryl
Posted: Fri Feb 19, 2010 12:42 pm
by blue68f100
Spray it down with weld splatter spray before using it. It is a liquid to keep welding splatter from sticking and will make cleanup a lot easier. Then you can use your normal Hoppers #9 to clean it.
Posted: Fri Feb 19, 2010 5:56 pm
by recumbent
The o ring doesn't need to come off. Splatter shield is a big help if you use it B4 you shoot it.
Posted: Sat Feb 20, 2010 3:09 am
by SD Handgunner
Does anyone know how much the Volquartsen V-Comp weighs and how long it is (ie how much does it add to the overall length of the Handgun)?
Thanks
Larry
Posted: Sat Feb 20, 2010 7:15 am
by recumbent
SD Handgunner wrote:Does anyone know how much the Volquartsen V-Comp weighs and how long it is (ie how much does it add to the overall length of the Handgun)?
Thanks
Larry
the comp is over an inch in diameter and 2 1/4" long not sure what they weight.