Page 1 of 1
Mark II and Mark III grips
Posted: Sat Nov 12, 2005 10:39 pm
by bullbarrel
Would anyone happen to know if the Mark III grips will fit the Mark II without modification? Thanks to any and all who reply, Bull.
Posted: Sun Nov 13, 2005 11:44 am
by Bullseye
No modifications are necessary to install Mark III grip panels onto a Mark II.
R,
Bullseye
Posted: Sun Nov 13, 2005 1:18 pm
by bullbarrel
Thanks for the answer I was hoping for Bullseye! I want to install a pair that I found in Ruger's catalog, the checkered cocobolo #90256 on an older Mark II I have. Thanks again for your help, Brad.
Posted: Mon Jan 16, 2006 10:42 pm
by mudbone
...so why does the company say they don't fit?
________
Vermont dispensary
Posted: Tue Jan 17, 2006 8:53 pm
by Bullseye
I haven't a clue why they take that position. But they say that a lot about compatible parts between these two models. I have swapped grips between both model pistols, back and forth, and they fit just fine after I cut a 3/8'' relief hole in the Mark II grips for the Mark III's magazine release screw. I didn't have to do a thing to put MKIII's onto the MarkII, just screw them in.
R,
Bullseye