Page 1 of 1

Replacing sear on Mark 3 Hunter.

Posted: Wed Aug 20, 2008 10:47 am
by PISTOLERO
Thanks to Bullseye's suggestions I replaced the Sear on my hunter. The trigger pull was considerably reduced. I also replaced the trigger just because VQ had them on sale for $15.00. I watched the VQ video over and over before and during installation. It helped tremendously. I saved time and money, again because of Bullseye's guidance.
THANK YOU.

Posted: Wed Aug 20, 2008 1:49 pm
by Bullseye
As always, you're very welcome. I'm very happy that you found the info here helpful. But I didn't do the work, you did. All I did was make the information available for you to satisfactorily tune your pistol.

Now go out and enjoy that pistol!

R,
Bullseye