Using a scope and iron sights
Posted: Mon May 15, 2006 6:36 pm
I saw a question about this on the other forum and just got mine finished so I thought I'd post the results.
I used B-Square see through rings and sawed the flat off above the screw that attaches the rings to the rail/mount.
The rings seem to be sturdy enough that the lack of this support won't affect the strength of the rings.
The One Ragged Hole rear sight blade combined with the Williams front almost make a poor mans red dot at short ranges.
[img][img]http://i2.photobucket.com/albums/y36/bo ... 000009.jpg[/img][/img]
I used B-Square see through rings and sawed the flat off above the screw that attaches the rings to the rail/mount.
The rings seem to be sturdy enough that the lack of this support won't affect the strength of the rings.
The One Ragged Hole rear sight blade combined with the Williams front almost make a poor mans red dot at short ranges.
[img][img]http://i2.photobucket.com/albums/y36/bo ... 000009.jpg[/img][/img]
