GunTalk-Online.com

While going through Bullseye sticky's I saw one place describing the different trigger available for the MKIII. It said the factory trigger on the target model had an internal overtravel adjustment. How come nobody ever talks about this adjustment.

chasfred wrote:While going through Bullseye sticky's I saw one place describing the different trigger available for the MKIII. It said the factory trigger on the target model had an internal overtravel adjustment. How come nobody ever talks about this adjustment.

It is ther one most of the target models and may be on all models, you have to remove the trigger to adjust it, but once set properly you will probably never have to touch it again. Is is on the upper front of the trigger above the pivot pin hole.

Great answer Len!



The yellow arrow points to the location of the factory overtravel adjusting screw on the trigger.

R,
Bullseye

Bullseye wrote:Great answer Len!



The yellow arrow points to the location of the factory overtravel adjusting screw on the trigger.

R,
Bullseye

Thanks Bullseye, I didn't get this old by being forgetful, or did I?