Ruger MK II houge grips

Decado · Post by **Decado** » Thu May 15, 2008 12:14 pm

How do I mod them to fit the MKIII? I know it should not be hard, I am just wondering what tools you guys use to cut away material for the mag release.

jrayb95 · Post by **jrayb95** » Thu May 15, 2008 6:18 pm

I used an Exacto Knife. It doesn't take much.

Post by **Bullseye** » Thu May 15, 2008 9:51 pm

You can use a 3/8ths inch drill bit to start and get the outline and then clean it out with an x-acto knife.

R,
Bullseye

Decado · Post by **Decado** » Fri May 16, 2008 5:21 am

Thanks J and Bullseye for responding

, I figured I could use an exacto knife for that, just wanted to get an idea before I go off cutting on some grips.

Thank you for the quick response.