GunTalk-Online.com

How do I mod them to fit the MKIII? I know it should not be hard, I am just wondering what tools you guys use to cut away material for the mag release.

I used an Exacto Knife. It doesn't take much.

You can use a 3/8ths inch drill bit to start and get the outline and then clean it out with an x-acto knife.



R,
Bullseye

Thanks J and Bullseye for responding , I figured I could use an exacto knife for that, just wanted to get an idea before I go off cutting on some grips.

Thank you for the quick response.