45acp 200gr lswc loads

The place to discuss your favorite centerfire pistols.

Moderators: Bullseye, Moderators

User avatar
bgreenea3
Master contributor
Master contributor
Posts: 1587
Joined: Sun Sep 06, 2009 9:35 pm
Location: SW Michigan

45acp 200gr lswc loads

Post by bgreenea3 » Fri Feb 26, 2010 12:08 am

what loads do you guys like for 45acp 200gr lswc? jsut for paper punchin'

I'm giving 5.0 gr of unique a try, i've moslty shot 230gr lrn in my 1911 on top of universal clays with fairly good success.. I'm trying to branch out to new powders and loads for stuff, and am wondering what others like.

User avatar
bearandoldman
Ye Loquacious Olde Pharte
Ye Loquacious Olde Pharte
Posts: 4194
Joined: Tue Aug 16, 2005 10:30 am
Location: Mid Michigan

Re: 45acp 200gr lswc loads

Post by bearandoldman » Fri Feb 26, 2010 5:50 am

bgreenea3 wrote:what loads do you guys like for 45acp 200gr lswc? jsut for paper punchin'

I'm giving 5.0 gr of unique a try, i've moslty shot 230gr lrn in my 1911 on top of universal clays with fairly good success.. I'm trying to branch out to new powders and loads for stuff, and am wondering what others like.
Both of those powders are good, I use Green Dot because I had a lot from my old sporting clays shotgun loads. Those powders are all pretty close to the same burn rate. You have to use enough to make the gun run. I belive I used about 5.8 of Green dot with a 200LSWC and the Micro runs great on them. The Micro does not lie soft loads and it will not run them, just stubborn I guess. Ran into problems year ago before I strted re loading using Wolf ammo because it was cheap, their loads are a little on the soft side and now and then one would not make the slide run far enough to eject, CCI Blazer did because they were fairly hot.
You have great day and shoot straight and may the Good Lord smile on you.
Image

User avatar
Bullseye
Site Admin/Host
Site Admin/Host
Posts: 6382
Joined: Sun Aug 14, 2005 12:23 pm
Location: USA

Post by Bullseye » Fri Feb 26, 2010 5:57 am

I like using Alliant Bullseye pistol powder at 4.2 grains for 200gr. LSWC with a light taper crimp. I've gone as low as 3.8gr. with it, but 4.2gr. of Bullseye is the ideal diet for my wadcutter guns.

R,
Bullseye
Image

Pete D.
Regular contributor
Regular contributor
Posts: 132
Joined: Fri Dec 11, 2009 8:30 am
Location: Brooklyn, NY and Pennsylvania

.45 ACP

Post by Pete D. » Fri Feb 26, 2010 6:05 am

I use a 200 grain LSWC and 4.0 grains of Bullseye. I have lightened the recoil spring to 14 lbs.
Pete
"Only hunting and mountain climbing are sports. The rest are just games." - R.Ruark

jrayb95
New member
New member
Posts: 32
Joined: Sat Jul 14, 2007 4:37 pm
Location: Montrose, CO

Post by jrayb95 » Fri Feb 26, 2010 9:14 am

I use 200 grn. LSWC with 4.1 grn Bullseye and seems to work pretty smooth for me.

User avatar
bearandoldman
Ye Loquacious Olde Pharte
Ye Loquacious Olde Pharte
Posts: 4194
Joined: Tue Aug 16, 2005 10:30 am
Location: Mid Michigan

Post by bearandoldman » Fri Feb 26, 2010 10:07 am

jrayb95 wrote:I use 200 grn. LSWC with 4.1 grn Bullseye and seems to work pretty smooth for me.
looking at all the different loads and different powders of varying burn rates, I would dare say all of those loads are mostlekely within a 50 fps rnge.
Use what works for you and what you happen to have on hand.
You have great day and shoot straight and may the Good Lord smile on you.
Image

greener

Post by greener » Fri Feb 26, 2010 7:26 pm

Lately, I've liked 5.7 gr of Universal with 200 gr lswc's. Seem to work well in the PT1911, P90 and Blackhawk. 5.3 gr of W231 and 4.3 gr Bullseye are pretty good loads.

User avatar
bgreenea3
Master contributor
Master contributor
Posts: 1587
Joined: Sun Sep 06, 2009 9:35 pm
Location: SW Michigan

Post by bgreenea3 » Fri Feb 26, 2010 10:26 pm

OK, so far Boam likes green dot, a couple votes for 4.,0-4.3gr oof bulleseye, dad likes Bulleseye UC and W231...

anybody try winchester auto comp? any good?

greener

Post by greener » Fri Feb 26, 2010 11:30 pm

Interesting spread

Lee's Modern reloading shows 4.0 gr Bullseye at 790 fps
4.3 gr Green Dot 805 (the load they show for 200gr jacketed is 5.8 gr, 897 fps)

Smith's reloading http://www.reloadammo.com/ for 200gr lswc shows
Bullseye 4.2 gr 790 fps
Unique 5.1 gr 810 fps
Universal 5.4 gr 804 fps
and W231 5.5gr 910 fps

You certainly have room to play around with the loads

MtStream
New member
New member
Posts: 23
Joined: Mon Feb 01, 2010 12:23 pm

Post by MtStream » Sat Feb 27, 2010 3:24 am

I've been using a starting load of 3.2gr Clays with a 200 lswc (cream puff load). Tried it and liked it enough to not work up slowly. With the .38 158 lswc, I reduce the charge to 3.1gr. Pretty economical, consistent powder measuring and so easy to shoot.

User avatar
bearandoldman
Ye Loquacious Olde Pharte
Ye Loquacious Olde Pharte
Posts: 4194
Joined: Tue Aug 16, 2005 10:30 am
Location: Mid Michigan

Post by bearandoldman » Sat Feb 27, 2010 7:47 am

bgreenea3 wrote:OK, so far Boam likes green dot, a couple votes for 4.,0-4.3gr oof bulleseye, dad likes Bulleseye UC and W231...

anybody try winchester auto comp? any good?
Oldman likes Green Dot, mostly because he had 3 pounds or better left over from his sporting clays shotgunning days. If you look art a powder furn rate chart you will see a lot of different powders in the same range as Green Dot, like 700X 231 Int and Univ Clays, Unique. Bullseye is a great pistol powder nd always has bee, it is near the top of the burn rate chart and is great in short barrel guns. 296, H110 and 2400 are also used in.38/.357 but would probably be better in the long barrels as it's burn rate is a lot slower.
You have great day and shoot straight and may the Good Lord smile on you.
Image

User avatar
bgreenea3
Master contributor
Master contributor
Posts: 1587
Joined: Sun Sep 06, 2009 9:35 pm
Location: SW Michigan

Post by bgreenea3 » Sat Feb 27, 2010 8:35 am

bearandoldman wrote:
bgreenea3 wrote:OK, so far Boam likes green dot, a couple votes for 4.,0-4.3gr oof bulleseye, dad likes Bulleseye UC and W231...

anybody try winchester auto comp? any good?
Oldman likes Green Dot, mostly because he had 3 pounds or better left over from his sporting clays shotgunning days. If you look art a powder furn rate chart you will see a lot of different powders in the same range as Green Dot, like 700X 231 Int and Univ Clays, Unique. Bullseye is a great pistol powder nd always has bee, it is near the top of the burn rate chart and is great in short barrel guns. 296, H110 and 2400 are also used in.38/.357 but would probably be better in the long barrels as it's burn rate is a lot slower.
296,h110, and 2400 are great in heavy bullets and long barrels I would add Bluedot to that list too....

User avatar
bearandoldman
Ye Loquacious Olde Pharte
Ye Loquacious Olde Pharte
Posts: 4194
Joined: Tue Aug 16, 2005 10:30 am
Location: Mid Michigan

Post by bearandoldman » Sat Feb 27, 2010 8:46 am

Little Greener, all of those should work great in a .38 lever gun. But, I will stick to mmy Green Dot load, because it is very accurate ans I got the powder.
You have great day and shoot straight and may the Good Lord smile on you.
Image

perazzi
Moderator
Moderator
Posts: 360
Joined: Sat Jan 16, 2010 7:49 pm
Location: Hell, Michigan!

Post by perazzi » Sat Feb 27, 2010 8:38 pm

When (and if) I ever get my GC back from Colt :roll: , I'll be the guinea pig for Alliant on some ClayDot loads for .45 acp... They said " Let us know how it works out" lol

:wink:
Image

User avatar
bgreenea3
Master contributor
Master contributor
Posts: 1587
Joined: Sun Sep 06, 2009 9:35 pm
Location: SW Michigan

Post by bgreenea3 » Mon Mar 01, 2010 9:02 pm

I took 5.0gr of unique w/a 200gr lswc to the range today and it shot fairly well...about the same as 5.0 gr of Universal clays w/ 230 gr lrn....I think I'm going to pick up a pound of bullseye and maybe something else and try that next...... auto comp maybe

Post Reply