MKIII extractor replacement ?

tom234 · Post by **tom234** » Fri Sep 05, 2008 4:55 pm

I've got a new VQ extractor ready to go in but I can't seem to get the old one out. I've tried to search past posts but haven't found anything detailing extractor replacement. Is there a simple trick I'm missing ?

bearandoldman · Post by **bearandoldman** » Fri Sep 05, 2008 5:35 pm

tom234 wrote:I've got a new VQ extractor ready to go in but I can't seem to get the old one out. I've tried to search past posts but haven't found anything detailing extractor replacement. Is there a simple trick I'm missing ?

http://www.1bad69.com/ruger/extractor.htm

Try this it should help you out

jjfunk · Post by **jjfunk** » Fri Sep 05, 2008 5:57 pm

http://guntalk-online.com/detailstrip.htm#bolt

near the bottom of the page.

JJ

tom234 · Post by **tom234** » Fri Sep 05, 2008 6:54 pm

Ugh, removing the firing pin retention pin was the key....
Once again, Thanks guys.

bearandoldman · Post by **bearandoldman** » Fri Sep 05, 2008 7:10 pm

tom234 wrote:Ugh, removing the firing pin retention pin was the key....
Once again, Thanks guys.

Ayup, got to have room to work.

GunTalk-Online.com

MKIII extractor replacement ?

MKIII extractor replacement ?

Re: MKIII extractor replacement ?